Abrasive resistant lining mix AC17
Abrasive resistant lining mix AC17
Siberian lining company LLC. is pleased to offer you to supply abrasion-resistant repair and lining mix AC17 of Russian production.
AC 17 is used to restore and protect against erosion, abrasive, impact wear of equipment components by the transported material, including containers, trays, sand baths, grooves, collectors, hydrocyclones, ducts, outlets, pipes, sumps, distributors, screens, and t .d
The AC 17 is an efficient, easy-to-use and cost-effective replacement for imported analogs such as Aluma Plate, Devcon®, Loctite®, Nordbak®, etc.
|
MATERIAL DESCRIPTION
|
The abrasion-resistant repair-lining mix AC17 is a plastic mass obtained by mixing a TWO-COMPONENT COMPOSITION consisting of:
- COMPONENT A, based on epoxy-polyester resin, thickener and wear-resistant filler based on multi-fractional quartz sand, corundum or / and ceramic filler.
- COMPONENT B - amine type hardener.
|
|
APPLICATION
|
Restoration and protection from erosion, abrasive and impact wear of equipment components with particles of the transported material, including:
- tanks, trays, baths of sand, gutters, collectors, hydrocyclones, ducts, outlets, pipes, sumps, arc sieves, distributors, crusher centrifuge loads, screens, metering devices, separators, etc .;
-
air ducts, internal surfaces of pumping and ventilation equipment, valves and pipeline fittings.
|
|
ADVANTAGES
|
- Full cure time ≤ 1.5 hours after application.
-
Not afraid of residual moisture.
-
Does not require thorough surface preparation.
-
High adhesion to metal and concrete.
-
Differs in the increased resistance to abrasive wear and shock loadings.
-
Does not cause corrosion of metals and alloys.
-
It is resistant to water, natural gases, saturated solutions of salts, petroleum - motor oil, diesel fuel, gasoline, antifreeze, with the exception of prolonged contact with concentrated acids and organic solvents.
-
The thixotropy of the material prevents the spontaneous draining of the working mass from vertical and ceiling surfaces.
|
|
APPEARANCE AND COLOR
|
BASE (COMPONENT "A") - homogeneous plastic mass of steel color
COMPONENT "B" - a fluid composition of dark brown color
|
|
VIABILITY OF THE MIXTURE BEFORE THE BEGINNING OF THE CURING COSTS WITH A THICKNESS OF THE LAYER OF THE MIXTURE OF 10 MM
|
30-40 min (depending on temperature conditions) 1 kg of mixture per 600 sm2 of surface
|
|
Properties of the cured material
Tests according to GOST 25.503, GOST 14759 and GOST 14760 after holding the samples for 24 hours at a temperature of + (20 ± 5) ° С.
|
|
Compressive strength, MPa
|
≥ 70
|
|
shear strength, MPa
|
≥ 15
|
|
Tearing strength, MPa
|
≥ 20
|
|
Shore D hardness, unit HSD hardness
|
≥ 80 HSD
|
|
Operating temperature:
- dry environment, ° C
- humid environment, ° C
|
of - 60 to +90
of - 60 to +90
|
|
Packing
|
hermetically sealed container made of a material that does not enter into chemical interaction with the components of the mixture, equipped with an opening control ring or seal.
|
|
Standard net weight, kg
|
1kg, 3kg, 10kg, 20kg
|
